Applying UDL load on Composite Member
I have a model with composite section of beam and top slab with diaphragms. I would like to check if there is a way to apply area load on the slab surface?
In the above model, I would like to apply area load to the plane defined by node (22.214.171.124). However, some plane inside only have 3 edge support so it's not possible to put the floor loads. For example, i can put the load on (19,17,18,20) but i cannot put load on (30,19,17,29).
Is there a way to apply area load on the above problem.
You can do it with the Floor Load function below. Please refer to the online help for details.