Assign Single layer Rebar for slab

Question:

Hello,

How do I assign single layer of mesh for my slab.

Thanks.

Attached herewith my modal for your review 

Answer:
Hello,

Thank you for waiting us !
Unfortunately, we only support the double layer rebar for slab.
However, in case of your model file, if you set the concrete face to center of the rebar as 0.0325m, double layer will be located the center of the section together. Therefore you can check the flexural design result.
Thank you.

Best regards,
Jihong Hwang

Hello,

How about shear wall, can this program assign for single layer reinforcement.

Thanks & Regards,


Hello,

Unfortunately, for the shear wall, also we support the double layer only.
Thank you.

Best regards,
Jihong Hwang
Creation date: 7/25/2018 2:55 AM (dklee@midasit.com)      Updated: 7/25/2018 12:25 PM (dklee@midasit.com)
Files
check shear slab3.mgb